Business Wi-Fi
Business Wi-Fi that holds up when everyone's on it
Most bad Wi-Fi comes down to where the access points are, not which ones you bought. We survey the space, design coverage around how the building is built, and validate real throughput before we call it finished.
At a glance
- Predictive and on-site surveys
- Cabled access points, not repeaters
- Guest and staff networks separated
- Throughput validated at hand-over
Why consumer mesh fails in a business
A mesh kit from a big-box store solves coverage by relaying: each hop roughly halves the available bandwidth, and the relay competes with the clients for airtime. In a house with six devices that's fine. In an office with forty, it collapses precisely when everyone needs it.
Business access points are cabled back to the switch, so every AP has full backhaul. Add proper channel planning and power tuning and you get consistent throughput instead of a strong signal that can't move data.
The full comparison is in mesh Wi-Fi vs access points, and mesh installs are on the mesh Wi-Fi page.
Coverage is not the same as capacity
Full bars in every corner means nothing if thirty devices are sharing one radio. We design for the number of concurrent devices in each area, not just the floor plan, which usually means more access points at lower power rather than fewer at maximum.
What you get
Included as standard unless it says otherwise. Add-ons are priced separately and named as such.
- Site surveyPredictive design plus on-site validation against the real building.
- Access point placementPositions chosen for capacity and construction, not convenience.
- Cabling to each APEvery AP fed with its own cabled run and PoE.
- Channel & power planningTuned to avoid self-interference and neighbouring networks.
- Network separationGuest, staff and device networks segmented.
- Throughput validationMeasured performance in each area, documented at hand-over.
- Workmanship warrantyIncluded: 1 year from install. Anything our installation caused is fixed at no charge. Equipment carries the manufacturer’s warranty.
The process, start to finish
Every job follows the same shape, so you always know where you are in it.
Coverage survey
We walk the space, note construction, and map where devices are.
Design & quote
AP count, positions, cabling and switching scoped and priced.
Cable & mount
Runs pulled to each AP position, APs mounted and powered over Ethernet.
Configure
SSIDs, VLANs, guest isolation, channel and power plan applied.
Validate
Throughput and coverage measured in each area against the design.
Document & hand over
Network diagram, SSID and IP scheme documented. Sign-off.
Want this scoped for your site?
Call, or text a photo of the space. You get a straight answer on what the job involves.
Before you call
How many access points do we need?
It depends on device count and construction far more than square footage. A brick-walled 3,000 sq ft office can need more APs than an open 6,000 sq ft floor. The survey answers it.
Can you improve Wi-Fi without re-cabling?
Sometimes. Poor channel planning and badly placed APs are common and fixable. But if there's no cabling to good AP positions, adding cable is what solves it.
Do you set up a separate guest network?
Yes, and we'd recommend it as standard. Guest traffic isolated from your internal network, with its own bandwidth limits.
What brands do you install?
UniFi for most business deployments. It's reliable, well-priced and you keep full control. We'll work with what you have if you're already invested elsewhere.
Towns we serve: Oshawa, Whitby, Ajax, Pickering, Bowmanville, Port Perry, Belleville & Quinte West, Cobourg & Port Hope and Peterborough & the Kawarthas. Finished installs are on our work.