Cabling
Old cable removal for tenant move-outs and lease-end work
Commercial leases often ask the tenant to take out their data and low-voltage cabling when they leave, and landlords want a clear ceiling before the next fit-out. We pull the old cable, take down what was mounted, and photograph the space so both sides can see what was done.
At a glance
- Data, phone, camera and alarm cabling
- Racks, panels and wall plates taken down
- Old cable taken away, not left in the ceiling
- Before and after photos for the landlord
When this comes up
The usual trigger is a lease clause. The wording varies, but restoration or make-good clauses often require the space back without the tenant's cabling, and a landlord can hold part of the deposit until it is done.
The other side is the property manager who has inherited a unit with cable from two or three past tenants. The next installer cannot tell what is live, so new cable goes in beside the old, and the ceiling gets fuller at every turnover.
What comes out, and what stays
The scope is agreed in writing before we start: which runs come out, which stay for the next tenant, and what happens to the rack, patch panels and wall plates. Cable that another tenant or the building still uses stays where it is, and it is traced before anything is cut.
Wall plates come off and the boxes get blank covers, so no open holes are left in the drywall. Patching and paint are not part of the job unless you ask for them.
Where we stop
We do not touch fire alarm cabling. That belongs to the building's ULC-listed fire alarm contractor. Line-voltage wiring, including the circuit that fed a rack, is for a licensed electrician.
If the lease is unclear about what has to come out, check with your landlord or property manager before booking. We can price both versions so you can compare.
What you get
Included as standard unless it says otherwise. Add-ons are priced separately and named as such.
- Walk-through and scopeIncluded: which runs come out and which stay, agreed in writing.
- Tracing before cuttingIncluded: live runs and other tenants' cabling identified first.
- Cable removalIncluded: data, phone, camera and intrusion alarm cabling pulled back to source.
- Hardware removalIncluded: racks, patch panels, wall plates and mounts taken down.
- Blank coversIncluded, so no open boxes are left in the walls.
- DisposalIncluded: old cable and hardware taken away.
- Before and after photosIncluded, for your records or your landlord's.
- Drywall patching and paintAdd-on, or left to your general contractor.
The process, start to finish
Every job follows the same shape, so you always know where you are in it.
Walk-through
We see the space and go through the lease clause with you if you have it.
Written scope
What comes out, what stays, and the price.
Trace
Live runs and shared cabling found and marked.
Remove
Cable and hardware out, boxes covered, area swept.
Photos
Before and after photos sent when the job is done.
Want this scoped for your site?
Call, or text a photo of the space. You get a straight answer on what the job involves.
Before you call
Do I have to remove my cabling when the lease ends?
It depends on the lease. Look for a restoration or make-good clause, or ask your property manager. Some landlords want everything out, and some want the cabling left for the next tenant.
Can the cabling stay for the next tenant instead?
Yes, if the landlord agrees. We can test and label what stays, so the next tenant knows what they are getting.
What about the fire alarm wiring?
We leave it alone. Fire alarm cabling belongs to the building's ULC-listed fire alarm contractor.