Security

Intercoms and door entry: see who it is before you let them in

A locked front door only works if somebody can answer it. An intercom lets staff see and speak to whoever is outside, then let them in from a desk or a phone, without walking to the door or leaving it propped open.

5.0 on Google · scoped for your site, in Durham Region and beyond

At a glance

  • Video, audio or phone-app answering
  • Unlock from a desk, a phone or a schedule
  • Ties into access control and cameras
  • Single doors to multi-tenant lobbies

Audio, video or app: which one you need

An audio-only intercom is fine where staff can already see the door. Video earns its keep the moment the person answering can't: a back office, a second floor, a shipping door round the side. App answering goes one step further and rings a phone, which suits small teams that are often out, or a door that gets deliveries when nobody is at reception.

We'll tell you which one you need. A single shop door with a counter facing it rarely needs more than a good doorbell camera; a building with a lobby, several tenants or after-hours deliveries does.

Multi-tenant lobbies and buzzer panels

In a building with several tenants, the entry panel has to reach the right unit, show a directory visitors can use, and let each tenant release the door without being able to release anyone else's. Modern panels do this over the network or over the existing two-wire buzzer cabling, which often means an old buzzer system can be replaced without opening walls.

Property managers get the other half: adding and removing tenants from a screen instead of a site visit, and a log of when the door was released and by whom.

Tying it to access control and cameras

An intercom on its own answers the door. Joined to access control it also knows the door's schedule, so it can stay unlocked during business hours and only ring after hours. Joined to cameras, every call and every release is on video, which settles the question of who was let in at 7:40 on a Saturday.

Replacing an old buzzer system

Most old buzzer systems fail the same way: the handset in one unit dies, parts are discontinued, and the whole panel has to go. We survey what's there first. Where the existing wiring is sound, it's reused; where it isn't, we run new cable, and either way you get a quote before anything comes off the wall.

What you get

Included as standard unless it says otherwise. Add-ons are priced separately and named as such.

  • Door surveyDoor, frame, power and existing wiring checked before we quote. Charged, then credited against the job.
  • Entry panelAudio or video, surface or flush mount, rated for outdoor use where needed.
  • Answering pointsDesk stations, indoor monitors, phone apps, or a mix.
  • Door releaseWired to the existing strike or maglock, or new locking hardware where needed.
  • DirectoryTenant or department directory set up and easy to change.
  • IntegrationsAccess control schedules and camera recording of calls and releases.
  • Hand-overStaff or tenants shown how to answer and release, with a short guide.
  • Workmanship warrantyIncluded: 1 year from install. Anything our installation caused is fixed at no charge. Equipment carries the manufacturer’s warranty.
A building entry panel with a numeric keypad and speaker grille
Photo: betexion on Pixabay. Stock image.

The process, start to finish

Every job follows the same shape, so you always know where you are in it.

  1. Survey

    We check the door, frame, power and any existing intercom or buzzer wiring.

  2. Design & quote

    We agree the panel type, answering points and release method.

  3. Cable & mount

    We run new cable where it's needed, then install the panel and answering points.

  4. Connect the release

    We wire the door release and check egress from the inside.

  5. Configure

    Directory, call routing, schedules and app accounts are set up.

  6. Test & hand over

    Every call path is tested end to end, then shown to the people who'll use it.

Want this scoped for your site?

Call, or text a photo of the space. You get a straight answer on what the job involves.

Before you call

Can we answer the door from our phones?

Yes. Most current systems ring a phone app as well as, or instead of, a desk station, with live video and an unlock button.

Can you reuse our old buzzer wiring?

Often, yes. Many modern panels run over existing two-wire cabling. We test it during the survey and only quote new cable where the old runs won't carry it.

Is a doorbell camera from a big-box store good enough?

For a single door with one or two people answering, sometimes it is, and we'll say so. It stops being enough when you need several answering points, a tenant directory, a door release, or a record of who was let in.

What happens in a power cut?

Door hardware is specified so people can always get out. Whether the door stays locked or releases from the outside is chosen per door, and panels can be battery-backed.

Can it work with our existing access control?

Usually. We check compatibility during the survey. Where the two can't talk directly, the intercom can still trigger the same door release.